|
| LASHING LUGS | |
|
| | |
|
Standard lugs
| | | |
ARA weld-on lashing lugs
| ARB screw-on lashing lugs
| SWL
| 50 kN
120 kN |
Position-holding spring
| Facilitates lashing
Éliminates ratting |
Meets following requirements :
| STANAG 3548
Guide DGA TA N°27S-CAT
Specifics requirements of DGA |
|
Special lugs
| Lashing lugs on weld-on plates
Lashing lugs on screw_on plates |
|
| |
| |
| |
| | |
| | |
| SAPEM has been active in the field of aerotransport for more than 20 years, and is recodnized for the quality of it's products and innovative solutions.
SAPEM lashing products are designed to withstand crash situation loads, and to have no permanent deformation at the nominal force, regardless of the direction of the load.
This allows, without further development or approval work, to cover the relatively frequent cases where the load angle differs from the one of the DGA guide.
Beyond the supply of the lugs, SAPEM can assist in the following :
| - determination of the lashing points
- definition of the lashing plan
- justification of the lashing solution (structural analyis, tests on tension bench)
- tension test report |
Note : according to the guide EE TI G0 16 of DGA/TA, no permanent deformation of the structure is allowed, around the lashing lug.
Supplied technical documentation:
| • technical data sheets
• instructions for the welding of the lashing lugs
• tension test report according to the guide
• « CE » declaration of conformity |
| |
| | |
|
| |
| |
|